Processing non-HTTP sessions accepted by a WAN optimization profile with HTTP optimization

From the CLI, you can use the following command to configure how to process non-HTTP sessions when a rule configured to accept and optimize HTTP traffic accepts a non-HTTP session. This can occur if an application sends non-HTTP sessions using an HTTP destination port.

 

config wanopt profile edit default

config http

set status enable

set tunnel-non-http {disable | enable}

end

 

To drop non-HTTP sessions accepted by the rule set tunnel-non-http to disable, or set it to enable to pass non-HTTP sessions through the tunnel without applying protocol optimization, byte-caching, or web caching. In this case, the FortiGate unit applies TCP protocol optimization to non-HTTP sessions.

 

Processing unknown HTTP sessions

Unknown HTTP sessions are HTTP sessions that do not comply with HTTP 0.9, 1.0, or 1.1. From the CLI, use the following command to specify how a rule handles such HTTP sessions.

 

config wanopt profile edit default

config http

set status enable

set unknown-http-version {best-effort | reject | tunnel}

end

 

To assume that all HTTP sessions accepted by the rule comply with HTTP 0.9, 1.0, or 1.1, select best- effort. If a session uses a different HTTP version, WAN optimization may not parse it correctly. As a result, the FortiGate unit may stop forwarding the session and the connection may be lost. To reject HTTP sessions that do not use HTTP 0.9, 1.0, or 1.1, select reject.

To pass HTTP sessions that do not use HTTP 0.9, 1.0, or 1.1, but without applying HTTP protocol optimization, byte-caching, or web caching, you can also select tunnel. TCP protocol optimization is applied to these HTTP sessions.