NAT with IP address conservation

In a source or destination NAT security policy that accepts SIP sessions, you can configure the SIP ALG or the SIP session helper to preserve the original source IP address of the SIP message in the i= line of the SDP profile. NAT with IP address conservation (also called SIP NAT tracing) changes the contents of SIP messages by adding the source IP address of the originator of the message into the SDP i= line of the SIP message. The SDP i= line is used for free-form text. However, if your SIP server can retrieve information from the SDP i= line, it can be useful for keeping a record of the source IP address of the originator of a SIP message when operating in a NAT environment. You can use this feature for billing purposes by extracting the IP address of the originator of the message.

 

Configuring SIP IP address conservation for the SIP ALG

You can use the following command to enable or disable SIP IP address conservation in a VoIP profile for the SIP ALG. SIP IP address conservation is enabled by default in a VoIP profile.

config voip profile edit VoIP_Pro_1

config sip

set nat-trace disable end

end

If the SIP message does not include an i= line and if the original source IP address of the traffic (before NAT) was 10.31.101.20 then the FortiGate unit would add the following i= line.

i=(o=IN IP4 10.31.101.20)

You can also use the preserve-override option to configure the SIP ALG to either add the original o= line to the end of the i= line or replace the i= line in the original message with a new i= line in the same form as above for adding a new i= line.

By default, preserver-override is disabled and the SIP ALG adds the original o= line to the end of the original i= line. Use the following command to configure the SIP ALG to replace the original i= line:

config voip profile edit VoIP_Pro_1

config sip

set preserve-override enable end

end

 

Configuring SIP IP address conservation for the SIP session helper

You can use the following command to enable or disable SIP IP address conservation for the SIP session helper. IP address conservation is enabled by default for the SIP session helper.

config system settings

set sip-nat-trace disable end

If the SIP message does not include an i= line and if the original source IP address of the traffic (before NAT) was

10.31.101.20 then the FortiGate unit would add the following i= line.

i=(o=IN IP4 10.31.101.20)