Creating a new ICMP service in the CLI

The following is the creation of the same service using the command line.

 

config firewall service custom edit ICMP test4

set comment “For testing of proprietary network scanner” set category Network Services

set protocol ICMP

set icmptype 7 end

end

 

IP

8. For the Protocol Type field, choose IP from the drop down menu

9. In the Protocol Number field enter the numeric value based on the information found in “Protocol Number” on page 1013

10. Select OK to confirm the configuration

 

 

Example

Example settings for an IP.service.In this case it has been set up to communicate via an old protocol called QNX

Field                                                            Value

Name                                                           QNX

Comments                                                  For QNX communications to the Development Lab

Service Type                                               Firewall

Show in Service List                                  enabled

Field                                                            Value

Category                                                     Uncatagorized

Protocol Options

Protocol Type                                             IP

Protocol Number                                        106